SKF®
SY 1. FM

Ball bearing units consist of a precision wide inner ring bearing assembled into a housing made of cast iron or pressed steel. Units are pre-lubricated and are designed to slip fit on to the shaft. Locking method is either setscrew locking, eccentric self-locking or concentric. On cast iron and pressed steel units, the outside diameter of the bearing and the inside diameter of the housing are sphered, allowing the bearing to swivel within the housing to accommodate initial alignment.

SKF® Pillow Block Ball Bearing Unit, Standard-Duty, Series: SY Series, 1 in Bore, 3-3/4 to 4-1/2 in Bolt Center-to-Center Length, 1-7/16 in Base to Bore Centerline, 5-1/2 in Overall Length, 2.781 in Overall Height, Two-Bolt Base Mounting, Round Bore, 1-1/2 in Base Width, Eccentric Collar Locking Device, Single Lip Seal, Non-Expansion (Fixed) Expansion, 3150 lb Dynamic/1760 lb Static Load, 7000 rpm Maximum, Cast Iron, Uncoated

• Prelubricated with a high quality, long life lithium/calcium grease
• Sphered housing bore mates with sphered O.D. of bearing, allows unit to accommodate for initial errors in alignment
• Designation permanently laser marked for easy identification of unit
• Grade #10 balls, ground and honed raceways for precision, quiet running and higher speed capacity
• Molded glass fiber reinforced polyamide cage for durability and quiet running
• Slotted bolt holes allow for a range of base bolt spacings and provide for adjustment at installation
• Solid housing provides a robust base with high break strength
• Eccentric self-locking features a machined collar and bearing inner ring which act as mating cams when assembled on the shaft
• FM series units consists of grease-purgeable contact seal is comprised of a wear resistant elastomer lip bonded to a steel trash guard
• Narrow inner ring
• YET series insert

• Catalog https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/SKF_SY_1_2_FM_Catalog.pdf