Timken®
TAK1 1/2

Timken® ball bearing housed units feature a wide-inner-ring ball bearing for additional shaft support. Designed for mounting on straight shafts with a slip fit, these housed units are available in an extensive array of types and sizes to accommodate many industrial applications.

Timken®, TAK1 1/2, Pillow Block Ball Bearing Unit, Normal Duty, Series: TAK, 1-1/2 in Bore, 5.374 in Bolt Center-to-Center Length, 1.937 in Base to Bore Centerline, 7.063 in Overall Length, 2-7/32 in Overall Width, 4 in Overall Height, Two-Bolt Base Mounting, Round Bore, 2.031 in Base Width, Eccentric Locking Device, Tri-Ply Shroud Seal, Non-Expansion (Fixed), 7330 lb Dynamic/4460 lb Static Load, 250 deg F, 500 rpm Maximum, Cast Iron, Uncoated

• Heavier than our standard block with solid, flat feet for increased strength
• Compact, one-piece housing can be mounted in any position
• Pillow blocks self-align at mounting with the spherical outside diameter of the bearing fitting into the corresponding spherical housing seat
• Pre-lubricated and ready for immediate installation
• Grease fitting for relubrication
• All units are supplied with G-KPPB tri-ply seal wide-inner-ring ball bearing and locking collar
• TAK with G-KPPB (tri-ply seal) wide-inner-ring ball bearings

• Catalog https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Timken_010_6015S_Catalog.pdf
• Specification S... https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Timken_TAK1_1_2_Specification_Sheet.pdf