INA
HK2520-2RS-L271

Drawn cup needle roller bearings with open ends are supplied with a needle roller and cage assembly or a full complement needle roller set. Bearings with needle roller and cage assemblies allow higher speeds than the full complement designs.

INA Drawn Cup Needle Roller Bearing, Series: HK Series, 25 mm Bore, 32 mm OD, 1 Rows, 20 mm Width, Double Seal Closure, 15600 N Load, Sheet Steel Cage, 6100 rpm Maximum, -20 to 100 deg C

• The bearings are particularly suitable for applications with a very small radial section height on account of their very low cross-sectional height
• Used if the housing bore is not suitable as a raceway for needle roller and cage assemblies
• Can support high radial loads
• Require a considerably smaller radial design envelope than machined needle roller bearings
• Usually run directly on the shaft
• Permit relatively high speeds
• Easy to mount
• Require no additional means of axial retention
• Can be readily used to close off the shaft ends of bearing positions
• Result in particularly compact, cost-effective and economical bearing arrangements
• Contact seal on both sides
• L271 anti wear protection grease
• 15600 N dynamic/24000 N static

• Warranty Inform... https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/INA_NIPA1_Warranty.pdf